Loading Z-Fold Paper - A&D Omniace III RA2300A Instruction Manual

(4) Pull out the paper
Insert the paper in the opening under the platen roller (block roller) of the recording section and pull
it out about 10 cm..
(1) Insert the paper under the platen roller
(2) Pull the paper out about 10 cm
(5) Close the cover
After pulling the paper, close the cover firmly pressing down on both sides (until a click is heard).
Pull the paper out keeping it straight. When using not to push both sides of the paper into the
recording section, the paper is not normally recorded.

3.2.2. Loading z-fold paper

To use z-fold paper (YPS112), a z-fold paper case (RA12-103, sold separately) is required.
《Z-fold paper》
YPS112
・Length: 200 m
・Folded width: 30 cm
・To indicate how much paper is remaining, a
page number (669 to 000) is printed on each
page.
Use only the z-fold paper prepared exclusively for this recorder by our company. If other
ＮＯＴＥ
types are used, the recording quality cannot be guaranteed, and the normal operation of
the paper feed may be affected.
《Z-fold paper case》
Z-fold paper case: RA12-103
・Z-fold paper case: About 3 kg
・A z-fold stock box ( about 300 g) comes with the z-fold paper case
・A z-fold paper case adaptor: About 200 g
《External dimensions of z-fold paper case》
See the drawing in 18.15. 6.
RA2300A Recorder (7001754-R01)
3-5
3. Pre-measurement Procedures
Recording
chart paper
Platen roller