Paper Loading; Paper Roll - A&D Omniace III RA2300A Instruction Manual

3. Pre-measurement Procedures

3.2. Paper Loading

Load either a paper roll or z-fold paper into this recorder.

3.2.1. Paper Roll

(1) Attach the paper holders to the paper roll.
Attach a paper holder to both ends of the paper roll. If loading a partially used roll, trim the edges for
ease of loading, as shown in the figure below.
Use only the paper roll prepared exclusively for this recorder by our company (YPS 106
ＮＯＴＥ
and YPS 108). If other types are used, the recording quality cannot be guaranteed, and
the normal operation of the paper feed may be affected.
Do not use the portion of the new roll that is covered with tape, as colors may not be
printed normally on this area.
(2) Open the cover of the recording paper section by raising the lock
(3) Load the paper in the compartment slots following the recorder
guide
Press the paper holders into the slots until a click is heard.
Be sure the paper roll is loaded so that the thermally sensitive side is face up; if this side
ＮＯＴＥ
is face down, the paper cannot be printed.
Pull the lock lever upwards.
Check the winding direction carefully.
Insert the paper holders into the slots.
3-4
RA2300A Recorder (7001754-R01)