Turning On The Power - A&D Omniace III RA2300A Instruction Manual

3. Pre-measurement Procedures

3.4. Turning on the Power

 When all the preparations are complete, turn on the recorder.
＜Points to be checked before applying power＞
Has this recorder been set on a safe place?
●
Has this recorder been set under a proper environment?
●
Is the power switch currently off?
●
Is this recorder grounded?
●
After confirming that these points above are all yes, turn on the recorder following to the steps
below.
(1) Connect the inlet side of the AC power cable to the AC socket of
this recorder
Connect the inlet side of the accessory AC power cable to the AC socket on the power supply
panel of this recorder.
(2) Connect the plug of the AC power cable to the power outlet
(3) Turn on the recorder power
Turn on the power switch located on the power supply panel of this recorder.
3. POWER switch ON
1. To
AC socket
AC power cable
3-10
3-pin power outlet
2. To power outlet
RA2300A Recorder (7001754-R01)