Commonly Used System Screen; Termination; Usb Drive Disconnection - A&D Omniace III RA2300A Instruction Manual

16.2.Commonly Used System Screen

Termination and USB Storage Disconnection, which are frequently used in the System screen, are placed
on the front.

16.2.1. Termination

This button initiates the termination processing of the recorder. After message of "You can shut off the
power" appears, turn off the power of this recorder.
Block data that is stored in a memory is saved. The data that is saved resumes at the next startup of
the recorder.

16.2.2. USB Drive Disconnection

This button is used to disconnect the USB storage devices that are connected to this recorder. After
this button is pressed, message of "You can disconnect USB devices" appears. Then, disconnect the
USB device.
USB storage device disconnection should be made while recording is not made. If the
NOTE
disconnection is made during recording, an error may occur. Use the USB storage device
that is recommended by NIPPON A&DNICS.
RA2300A Recorder (7001754-R01)
16.2.1Termination
16-3
16. System Setup (Other Functions)
16.2.2USB Drive Disconnection