Performing The Installation Wizard Of The Digitizer - AGFA CR Series Service Manual

DD+DIS155.11E
Evaluation:

If the scanned flatfield does not show one of the artifacts, no further action
is required.

If the scanned flatfield shows one of the artifacts compare the flatfield with the
limit pattern. For detailed instructions refer to chapter 3.3, Troubleshooting
5.5

Performing the Installation Wizard of the Digitizer

(1) Start the browser at the NX
workstation (A).
(2) Enter the digitizer IP
address
192.192.192.192 in the
address window (B).
(3) Enter username and
password obtained in the
digitizer web based training.
(4) Follow the installation
wizard.
Do not change the digitizer
network settings and the
destination settings. This is
done later, if required. See
section 4.2.
The controlled version of this document is available from the Agfa HealthCare Library. Any printed copy of this document is uncontrolled.
Edition 1, Revision 4
03-2013
Controls, Connections, and Setup Procedures
DOCUMENT CONTROL NOTE:
CR 10-X / CR Reader / CR 12-X / CR Advanced Reader
Type 5151 / 100 / 110 / 200 / 210
Figure 66
Digitizer Installation Wizards
Digitizer Settings Adapt local settings
Destination Settings
Site Specific Data
Adapt
Installation Date Confirmation
Figure 67
Agfa Company Confidential
B
192.192.192.192
Authentication Required
User Name:
C
Password:
OK Cancel
Start
Start
starts up automatically:
Next
Next
Do not change
Next
Confirm installation
install_poster_17a.cdr
Chapter 1 / Page 45 of 47
A
515101zf.cdr