Installation Preparation; Connecting The Cables - AGFA CR Series Service Manual

DD+DIS155.11E
5.1

Installation Preparation

(1) Prepare the installation as described in section 2 of this document.
5.2

Connecting the Cables

NOTE:
The devices are delivered with power cables for US and Europe. If a different cable
is needed, organize it locally. For cable specifications refer to:

Digitizer Service Manual, chapter 11, Installation Planning

NX Workstation Service Manual, chapter 3, Installation Planning
(1) Connect monitor, mouse,
keypad and license dongle
at the NX workstation.
(2) Connect the external power
supply.
(3) Connect the network cable
directly between digitizer
and NX workstation.
See also important note on
page 21.
The controlled version of this document is available from the Agfa HealthCare Library. Any printed copy of this document is uncontrolled.
Edition 1, Revision 4
03-2013
Controls, Connections, and Setup Procedures
DOCUMENT CONTROL NOTE:
CR 10-X / CR Reader / CR 12-X / CR Advanced Reader
Type 5151 / 100 / 110 / 200 / 210
Mains
HDMI to
DVI converter
(optional)
License
Dongle
Figure 17
Direct
network
connection
Mains
Figure 18
Chapter 1 / Page 22 of 47
Agfa Company Confidential
Mains
install_poster_02a.cdr
install_poster_003.cdr