Appendix: Installation Of The Digitizer Without Using The Cr 10-X / Cr 12-X Configuration Wizard - AGFA CR Series Service Manual

DD+DIS155.11E
5 Appendix: Installation of the Digitizer without using the
CR 10-X / CR 12-X Configuration Wizard
REQUIRED TIME:
The complete installation of the digitizer including installation and configuration of the
workstation takes approximately 1 hour.
REQUIRED DOCUMENTS
Chapter 4 of the corresponding NX Workstation version in the Agfa HealthCare Library:
Computed Radiography > CR Workstation Software
IMPORTANT:

The CR 10-X digitizer* is supported as of NX 2.0.8700 / 3.0.8700 only.

The CR 12-X digitizer** is supported as of NX 2.0.8800 / 3.0.8800 only.
* CR 10-X, subtype 100 or CR Reader, subtype 110
** CR 12-X, subtype 200 or CR Advanced Reader, subtype 210
NOTE:
The Installation Checklist in section 6 of this chapter gives an overview of all steps
of the digitizer installation and guides through the complete installation process.
IMPORTANT:
When using a direct network connection between digitizer and a NX workstation, first
switch on the digitizer, then the workstation. As alternative: With digitizer switched on
select at NX workstation:
START > All Programs > Agfa > NX > Restart NX completely
Workarounds to avoid a switch-on sequence:
Possibility 1: Use a network switch to connect digitizer and NX workstation.
Possibility 2: Connect digitizer and NX to the local network. See also section 4.2.
Possibility 3: Set a fixed IP address for the NX workstation. See NX service manual
chapter 4, Installation.
The controlled version of this document is available from the Agfa HealthCare Library. Any printed copy of this document is uncontrolled.
Edition 1, Revision 4
03-2013
Controls, Connections, and Setup Procedures
DOCUMENT CONTROL NOTE:
CR 10-X / CR Reader / CR 12-X / CR Advanced Reader
Type 5151 / 100 / 110 / 200 / 210
Chapter 1 / Page 21 of 47
Agfa Company Confidential