Electrical Connections At The Digitizer; Installation Guidelines For Electrical Installations In The Installation Room; Mains Connection In The Installation Room - AGFA CR Series Service Manual

DD+DIS170.11E
6.1

Electrical Connections at the Digitizer

Power Switch
IMPORTANT:
The external power supply is part of delivery. Do not use another power supply than
the one delivered with the digitizer or available from spare parts stock.
6.2

Installation Guidelines for electrical Installations in the Installation Room

Electrical installations have to be done in accordance with national regulations or
statutory requirements, e.g.:
VDE:
(Germany)
UL: (US)
6.3

Mains Connection in the Installation Room

Mains connection has to be available in accordance with national regulations or
statutory requirements, e.g.:
VDE:
(Germany)
UL: (US)
The controlled version of this document is available from the Agfa HealthCare Library. Any printed copy of this document is uncontrolled.
Edition 1, Revision 1
03-2013
POWER
External Power Supply
Electrical installations in the installation room must be in compliance
with the regulations IEC 364, VDE 0100 and VDE 0107.
Electrical installations in the installation room must be in compliance
with the regulations: "National Electrical Code" (NEC) (NFPA70).
Double earthed pin outlet in compliance with DIN 49441 and with
CEE 7 standard cover V II.
Earthed contact outlet for the NEMA 5-15 P plug
DOCUMENT CONTROL NOTE:
CR 10-X / CR Reader / CR 12-X / CR Advanced Reader Chapter 11 / Page 15 of 24
Type 5151 / 100 / 110 / 200 / 210
Installation Planning
Digitizer rear side
Figure 7
Agfa Company Confidential
1 2 3
USB Interface
Network Interface
24 V Power Input
515111ae.cdr