Install & Configure; Software Installation - AGFA CR Series Service Manual

DD+DIS155.11E
2.4 Install & Configure
2.4.1

Software Installation

The menu "Software Installation" allows to upload and install software for the digitizer.
Purpose
IMPORTANT:
Software installation can be performed via USB flash drive (checked to be virus-free) or
via any PC with network connection to the digitizer.
For software installation via USB flash drive:
Preferably use the USB flash drive which is connected in the rear of the digitizer. When
using a different USB flash drive be aware that the digitizer only accepts USB flash
drives with a certain specification (e.g. maximum size 4 GB).
For software update via network proceed
Usage
as follows:
(1) Select service menu <Software
Installation> to perform the
software installation via browser.
(2) Follow the instructions which are
enclosed to the digitizer software on
the Agfa HealthCare Library.
The controlled version of this document is available from the Agfa HealthCare Library. Any printed copy of this document is uncontrolled.
Edition 1, Revision 1
03-2013
DOCUMENT CONTROL NOTE:
CR 10-X / CR Reader / CR 12-X / CR Advanced ReaderChapter 3.2 / Page 13 of 31
Type 5151 / 100 / 110 / 200 / 210
Repair and Service
Tools and auxiliary Means
Figure 9
Agfa Company Confidential