Performing Setup Of The Nx Workstation - AGFA CR Series Service Manual

DD+DIS155.11E
5.3

Performing Setup of the NX Workstation

NOTE:
The NX workstation setup comprises following steps:

Performing the operating system settings (date & time, network, language)

Installing the license file

Activating the NX software

Configuring the digitizer on the NX workstation
(1) Switch on the digitizer.
The red status LED starts flashing.
(2) Switch on the NX Workstation.
(3) Login with service user name and
password obtained in the NX
classroom training.
IMPORTANT:
With direct network connection observe
the correct switch on sequence: First
switch on digitizer, then the NX
workstation.
To avoid a fixed switch on sequence
with direct network connection, use one
of the workarounds mentioned on
page 21.
The controlled version of this document is available from the Agfa HealthCare Library. Any printed copy of this document is uncontrolled.
Edition 1, Revision 4
03-2013
Controls, Connections, and Setup Procedures
DOCUMENT CONTROL NOTE:
CR 10-X / CR Reader / CR 12-X / CR Advanced Reader
Type 5151 / 100 / 110 / 200 / 210
User name
Password
Figure 19
Direct network connection:
Observe switch-on sequence
or use one of the available workarounds.
Figure 20
Chapter 1 / Page 23 of 47
Agfa Company Confidential
install_poster_04.cdr
install_poster_003a.cdr