Table of Contents
Advertisement
44 | CR Reader, CR Advanced Reader, CR Multiformat Reader | Getting started
Starting the Digitizer
To start the Digitizer:
1. Make sure the digitizer is connected to the control PC and that the control
PC is running the appropriate NX software.
For more information, refer to the NX User Manual.
2. Press the power button.
1.
The machine starts the following operation sequence:
• initialization of all components,
• functional test of all components,
• check for presence of cassettes and/or IPs,
• establish connection to the control PC.
During the self-test, which may take up to 3 minutes, the digitizer status
indicator is blinking red.
If the digitizer has completed the self-test successfully, the digitizer enters
the operator mode and the status indicator is continuously lighting up in
green.
2591D EN 20191028 1712
Note: Make sure not to insert a cassette if the device is switched
off or starting up.
Power button
Note: During the self-test, you cannot activate any functions.
1
Advertisement
Table of Contents
