Hardware Components Of The Digitizer - AGFA CR Series Service Manual

DD+DIS155.11E
3

Hardware Components of the Digitizer

The following figure shows the hardware components of the digitizer.
USB
Flash
Drive
The following table lists the functions of the different components in alphabetical
sequence.
# Component Name
1 Cassette Detection
Light Sensor
2 Device E-Label*
3 Drawer Motor
4 Erasure LED Board
External Power Supply
5
(24 V)
6 IP Detection Sensor
The controlled version of this document is available from the Agfa HealthCare Library. Any printed copy of this document is uncontrolled.
Edition 1, Revision 1
03-2013
Photomultiplier
Tube Board
Flash Memory
Optics Boards
PMI Board
Flash Memory
Power Board /
Power II Board
Ethernet
NX Workstation
Function
Detects that a cassette has been entered.
Master E-label for device specific parameters like serial number and
type number.
Transports the image plate from the cassette to the scan drum.
Drives the image plate back into the cassette after scan.
Keeps the LEDS of the Erasure Unit.
Supplies power for all consumers.
Detects the image plate approx. 24 cm after begin of scan.
DOCUMENT CONTROL NOTE:
CR 10-X / CR Reader / CR 12-X / CR Advanced Reader Chapter 2 / Page 10 of 19
Type 5151 / 100 / 110 / 200 / 210
Digitizer
Optic Module
EOL
BOL
Sensor
Sensor
E-Label
Device E-Label
E-Label
External Power
Supply (24 V)
Figure 8
Functional Description
User Interface
Board
Erasure LED
Board
IP Detection
Light Sensor
IP Drawer
Light Sensor
Cassette Detection
Light Sensor
Slow Scan Motor
M
Drawer Motor
M
Power
Data
(and Power)
Agfa Company Confidential
515102bc.cdr