Guidelines For Placing The Digitizer - AGFA CR Series Service Manual

DD+DIS170.11E
3.2

Guidelines for Placing the Digitizer

Observe following guidelines for the installation place of the digitizer:

Recommended table height: 75 cm

Due to the workflow* of the system it is recommended to install digitizer and
NX workstation close together.
* The operator has to go from digitizer to the NX workstation and back to the digitizer for each
scan cycle.
WARNING:
The device is a table-top digitizer. The structure and stability of the table used need to
be suitable in relation with the size and weight of the system. Do not use excessive
force when inserting cassettes in the digitizer as the device may slip or drop off the
table. Use a non-slip-mat below the digitizer or other anti-skid measures. The table
should not be subject to excessive shock and vibrations from other sources, as this
may disturb the operation of the digitizer.
The controlled version of this document is available from the Agfa HealthCare Library. Any printed copy of this document is uncontrolled.
Edition 1, Revision 1
03-2013
DOCUMENT CONTROL NOTE:
CR 10-X / CR Reader / CR 12-X / CR Advanced Reader Chapter 11 / Page 11 of 24
Type 5151 / 100 / 110 / 200 / 210
Installation Planning
Agfa Company Confidential
1 2 3