Main Components Of The Digitizer - AGFA CR Series Service Manual

DD+DIS155.11E
1.4

Main Components of the Digitizer

The digitizer consists of following main components:
# Component Name
1 Cassette Unit
2 IP-Drawer Module
3 Erasure Unit
4 Slow Scan Unit
5 Optic Module
6 PMT with Light
Collector
7 Power Board
8 PMI Board
9 USB Flash Memory
Cassette
The controlled version of this document is available from the Agfa HealthCare Library. Any printed copy of this document is uncontrolled.
Edition 1, Revision 1
03-2013
Purpose
Opens, closes and clamps the cassette.
Transports the image plate from cassette to slow scan
drum and back.
Erases the image plate while it is driven back.
Drives the image plate continuously during scanning
and erasure.
Creates the laser beam for scanning This beam
stimulates the image plate to emit blue light.
Collects the emitted blue light and converts it into an
electrical signal.
Controls the actuators and sensors for the image plate
(IP) run and the erasure unit.
Main board of the digitizer.
Keeps the digitizer configuration data and logfiles.
Optic Module
Slow Scan Unit
Erasure Unit
Cassette Unit
DOCUMENT CONTROL NOTE:
CR 10-X / CR Reader / CR 12-X / CR Advanced Reader Chapter 2 / Page 6 of 19
Type 5151 / 100 / 110 / 200 / 210
Functional Description
IP-Drawer Module
Figure 4
PMT with
Light Collector
PMI Board
USB Flash
Memory
Image Plate
Power Board
517502ca.cdr
Agfa Company Confidential