AGFA CR Series Service Manual page 155

DD+DIS155.11E
In general: The digitizer is not able to perform the hardware selftest.
Cause 4
Use the "Boot Problem Analyzer" to get more info about the problem.
Solution 4
Instructions:
(1) Switch off the digitizer.
(2) Remove the digitizer USB flash drive and insert it at the Service PC.
(3)
Copy the content of folder "ARC_1103*/BootProblemAnalyzer" (*or higher
version) to the root of the USB flash drive. See Figure 1.
(4) Release the USB flash drive from the Service PC and insert it at the digitizer.
(5) Switch on the digitizer.
The controlled version of this document is available from the Agfa HealthCare Library. Any printed copy of this document is uncontrolled.
Edition 1, Revision 2
03-2013
USB Flash Drive Contents before
.....
.....
and other files
DOCUMENT CONTROL NOTE:
CR 10-X / CR Reader / CR 12-X / CR Advanced Reader
Type 5151 / 100 / 110 / 200 / 210
Repair and Service
Troubleshooting
USB Flash Drive Contents
after preparation for the
Boot Problem Analyzer
.....
.....
and other files
.....
.....
Figure 1
Agfa Company Confidential
preparing_USB_for_boot_anaylzer.cdr
Chapter 3.3 / 7 of 46