Workflow Of A Digitizer System - AGFA CR Series Service Manual

DD+DIS170.11E
1.2

Workflow of a Digitizer System

The following figure shows the workflow of a digitizer system:
1 Insert cassette in X-ray table
and take exposure.
3 Enter patient and examination data
and click on the ID button: Scanning starts
5 Release cassette.
The controlled version of this document is available from the Agfa HealthCare Library. Any printed copy of this document is uncontrolled.
Edition 1, Revision 1
03-2013
A
constant
green
when
idle
DOCUMENT CONTROL NOTE:
CR 10-X / CR Reader / CR 12-X / CR Advanced Reader Chapter 11 / Page 7 of 24
Type 5151 / 100 / 110 / 200 / 210
Installation Planning
2 Insert exposed cassette in digitizer.
B
4 Wait until the image is scanned.
6 Insert the cassette in the X-ray table
for the next examination.
Figure 3
green
flashing
during
scan
Approx. 2 min.
Agfa Company Confidential
1 2 3
515102az.cdr