Performing The Installation Steps As Described In The Quick Installation Guide - AGFA CR Series Service Manual

DD+DIS155.11E
3 Performing the Installation Steps as described in the Quick
Installation Guide
(1) Perform all steps as described in the Quick Installation Guide, which is part of
delivery. The document is also available via Agfa HealthCare Library, Document
ID 34000041
NOTE:
After the installation with the Quick Installation Guide, the mandatory installation steps
for a standalone system are finished. The system status is as follows:
CR 10-X Status in the NX configuration menu:
Devices  Digitizer Configuration  Digitizer
#
1
2
3
4
5
6
7
The controlled version of this document is available from the Agfa HealthCare Library. Any printed copy of this document is uncontrolled.
Edition 1, Revision 4
03-2013
Controls, Connections, and Setup Procedures
(Intranet Link
Parameter
Name:
Enable Fast ID
Enable Auto Cropping
Device settings: IP Address
Device Settings: AE Title:
Device settings: Default Router
Device settings: Subnet Mask
DOCUMENT CONTROL NOTE:
CR 10-X / CR Reader / CR 12-X / CR Advanced Reader
Type 5151 / 100 / 110 / 200 / 210
/ Extranet Link).
Value
DIG_DEFAULT
Enabled
Disabled
192.192.192.192
DIG_DEFAULT
192.168.0.1
255.255.255.0
Figure 3
Chapter 1 / Page 7 of 47
Agfa Company Confidential