DD+DIS170.11E
4
System Integration
The system can be installed "standalone" or can be integrated into the local network:
Standalone Installation:
The digitizer can be connected
directly to the NX workstation. In
this case no other network access
to the NX workstation is possible.
The digitizer network settings are
pre-configured for this setup.
Integrated Installation:
After network setup of digitizer and
NX workstation the system can be
integrated into the local network.
The following table lists the information which is required if the digitizer is integrated
into the local network.
Parameter:
IP Address:
Subnet Mask:
Gateway IP Address*:
AE Title:
Hostname:
* Only required if a network gateway is used on site.
The controlled version of this document is available from the Agfa HealthCare Library. Any printed copy of this document is uncontrolled.
Edition 1, Revision 1
03-2013
Default value:
192.192.192.192
255.255.255.0
192.192.100.1
DIG_DEFAULT
192.192.192.192
DOCUMENT CONTROL NOTE:
CR 10-X / CR Reader / CR 12-X / CR Advanced Reader Chapter 11 / Page 12 of 24
Type 5151 / 100 / 110 / 200 / 210
Installation Planning
Standalone Installation
(Direct network connection)
NX Workstation
Digitizer
Network Cable
Integrated Installation
(Part of local network)
NX Workstation
Digitizer
Hospital Network
Figure 6
Value:
..............................................
..............................................
..............................................
..............................................
..............................................
Agfa Company Confidential
1
2
3
515100ad.cdr