Installation Checklist - AGFA CR Series Service Manual

DD+DIS155.11E
6

Installation Checklist

# Step
Installation Prerequisites
1. Check installation site prerequisites.
2. Unpack digitizer.
3. Unpack NX workstation and monitor
4. Check shipment completeness.
Performing The steps as described in the Quick Installation Guide
Perform the steps as described in the Quick
5.
Installation Guide.
Finalizing the Installation
6. Adding Windows and NX users.
If required: Configuring Digitizer and NX for the
7.
local Network
Setup of Connectivity to additional System
8.
Components
Customizing System Components according to
9.
Customer Preferences
10. Finalizing the Workstation Installation
11. Check digitizer software version
Performing further Activities depending on local
12.
Regulations
13. Customer Training
* Task Code, only applicable for Agfa employees
PRI = Pre-Installation
Ins = Installation task
ATR = Customer training
ASC = Configuration & Customization
The controlled version of this document is available from the Agfa HealthCare Library. Any printed copy of this document is uncontrolled.
Edition 1, Revision 4
03-2013
Controls, Connections, and Setup Procedures
DOCUMENT CONTROL NOTE:
CR 10-X / CR Reader / CR 12-X / CR Advanced Reader
Type 5151 / 100 / 110 / 200 / 210
Reference Okay
2.1
2.2
2.3
2.4
3
4.1
4.2
4.3
4.4
4.5
4.6
4.7
4.8
Chapter 1 / Page 47 of 47
Agfa Company Confidential
Task
code*
PRI
INS
INS
INS
INS
ASC
ASC
ASC
ASC
ASC
ASC
ASC
ATR