Suzuki SY413 Service Manual page 2716

B-10 TRANSMISSION RANGE SIGNAL CIRCUITS CHECK (G13 WITH A/T)
STEP
Check transmission range signal.
1) Connect SUZUKI scan tool to DLC with ignition
switch OFF.
2) Ignition switch ON and check transmission range sig-
nal on display under each condition give below.
Selector lever in "P" range position:
1
Selector lever in "R" range position:
Selector lever in "N" range position:
Selector lever in "D" range position:
Selector lever in "2" range position:
Selector lever in "L" range position:
Is check result satisfactory?
ENGINE GENERAL INFORMATION AND DIAGNOSIS (G13/G16 ENGINE WITH WU TWC) 6-1-117
ACTION
P
R
N
D
2
L
YES
D Wire open or short
Transmission range
D Poor each terminal
signal circuits are in
good condition.
If wire and connec-
tion are OK, check
transmission range
switch, referring to
Section 7B.
1. Battery positive voltage
2. Main fuse box
3. Ignition switch
4. "IG" fuse in J / B
5. Transmission range switch
6. PCM
NO
connection