4) Install lateral rod (1) and bolt (3) in proper direction as
shown. Then tighten nuts (4) temporarily by hand.
2. Vehicle body
A : Forward
5) Clean mating surfaces of axle housing (1) and differential
carrier and apply sealant to housing side.
"A" : Sealant 99000-31110
6) Install differential carrier assembly to axle housing and
tighten carrier bolts to specified torque.
Tightening torque
Rear differential carrier bolts : 23 N·m (2.3 kg-m, 17.0 lb-ft)
7) Install propeller shaft to joint flange aligning match marks (1)
and tighten flange bolts to specified torque.
Tightening torque
Companion flange bolts (a) : 23 N·m (2.3 kg-m, 17.0 lb-ft)
8) Install LSPV spring to rear axle.
Tighten LSPV adjust nut temporarily at this step. (if equipped
with LSPV).
9) Install wheel speed sensor and clamp wire securely (right &
left) (if equipped with ABS).
10) Remove floor jack from axle housing.
11) Connect brake flexible hoses (1) (right & left) to bracket on
rear axle and secure it with E-rings (3) (right & left).
12) Connect brake pipes to brake flexible hoses (1) and tighten
brake pipe flare nuts (2) to specified torque.
Tightening torque
Brake pipe flare nut (b) : 16 N·m (1.6 kg-m, 11.5 lb-ft)
REAR SUSPENSION 3E-11