Suzuki WagonR+ RB310 Service Manual page 1613

3E-6 REAR SUSPENSION
2) Press in a new bearing (2) and retainer ring (3) in order by
using an hydraulic press (4).
NOTE:
• Install wheel bearing spacer (1) with the tapered side of
its inner diameter directed toward outside (axle shaft
flange side).
• Install wheel bearing with its sealed side directed
toward outside (axle shaft flange side).
• Use care not to cause any damage to outside of
retainer ring and wheels sensor ring (if equipped with
ABS).
A : Tapered side
B : Sealed side
C : Differential side
D : Without ABS
E : With ABS
3) Inspect axle shaft length.
Rear axle shaft length "a"
Right side : 657.5 mm (25.9 in.)
Left side : 785.5 mm (30.9 in.)
4) Apply grease to axle shaft oil seal (1) lip as shown.
"A" : Grease 99000-25010
5) Apply sealant to mating surface (2) of axle housing and
brake back plate.
NOTE:
Make sure to remove old sealant before applying it anew.
"B" : Sealant 99000-31090
6) Install rear axle shaft to rear axle housing and tighten brake
back plate bolts to specified torque.
NOTE:
When installing rear axle shaft, be careful not to cause
damage to oil seal lip in axle housing.
Tightening torque
Brake back plate bolts (a) : 23 N·m (2.3 kg-m, 17.0 lb-ft)