Set Port Vid - ZyXEL Communications XS3800-28 User Manual

2
In the
Sta tic VL AN
descriptive name in the
VL AN G ro up ID
Note: The
VL AN G ro up ID
same VLAN ID.
3
Since the
VL AN2
permanent member of the VLAN only.
4
To ensure that VLAN-unaware devices (such as computers and hubs) can receive frames properly, clear
the
T X T a g g ing
5
Click to save the settings to the run-time memory. Settings in the run-time memory are lost when the
Add
Switch's power is turned off.
5.1.2 Se t Po rt VID
Use PVID to add a tag to incoming untagged frames received on that port so that the frames are
forwarded to the VLAN group that the tag defines.
In the example network, configure 2 as the port VID on port 1 so that any untagged frames received on
that port get sent to VLAN 2.
Chapter 5 Initial Setup Example
screen, select , enter a
AC T IVE
field and enter 2 in the
Na m e
field for the network.
VL AN2
field in this screen and the
network is connected to port 1 on the Switch, select
check box to set the Switch to remove VLAN tags before sending.
XS3800-28 User's Guide
field in the
VID
65
screen refer to the
IP Se tup
to configure port 1 to be a
Fixe d