Set Port Vid - ZyXEL Communications XGS2220 Series User Manual

The following screen appears. Click the switch to set this VLAN to Active, enter a descriptive name in the
2
Name field and enter "2" in the VLAN Group ID field for the VLAN2 network.
Note: The VLAN Group ID field in this screen and the VID field in the SYSTEM > IP Setup > IP
Status screen refer to the same VLAN ID.
Since the VLAN2 network is connected to port 1 on the Switch, select Fixed to configure port 1 to be a
3
permanent member of the VLAN only.
To ensure that VLAN-unaware devices (such as computers and hubs) can receive frames properly, clear
4
the Tx Tagging check box to set the Switch to remove VLAN tags before sending.
Click Apply to save the settings to the run-time memory. Settings in the run-time memory are lost when
5
the Switch's power is turned off.

5.1.2 Set Port VID

Use PVID to add a tag to incoming untagged frames received on that port so that the frames are
forwarded to the VLAN group that the tag defines.
In the example network, configure 2 as the port VID on port 1 so that any untagged frames received on
Chapter 5 Initial Setup Example
XGS2220 Series User's Guide
101