Using The Cli - TP-Link T1600G-18TS Configuration Manual

Configuring SNMP & RMON
Figure 6-10 Event Configuration
4) Choose SNMP > RMON > Alarm to load the following page. Configure entries 1 and 2.
For entry 1, set the alarm variable as BPackets, related statistics entry ID as 1 (bound
to port 1/0/1), the sample type as Absolute, the rising threshold as 3000, associated
rising event entry ID as 1 (which is the notify type), the falling threshold as 2000, the
associated falling event entry ID as 2 (which is the log type), the alarm type as all, the
interval as 10 seconds, the owner name as monitor. For entry 2, set the associated
statistics entry ID as 2 (bound to port 1/0/2). Other configurations are the same as
those of entry 1.
Figure 6-11 Alarm Configuration
5) Click Save Config to save settings.

6.5 Using the CLI

 Configuring Rate Limit on ports
Configure the rate limit on required ports. For detailed configuration, please refer to
Configuring QoS.
Configuration Example
Configuration Guide 736