Configuring Static Router Port - TP-Link T1600G-18TS Configuration Manual

Configuring Layer 2 Multicast
Step 5 copy running-config startup-config
Save the settings in the configuration file.
The following example shows how to enable MLD Snooping in VLAN 2 and VLAN 3,
configure the router port time as 500 seconds and the member port time as 400 seconds:
Switch#configure
Switch(config)#ipv6 mld snooping
Switch(config)#ipv6 mld snooping vlan-config 2-3 rtime 500
Switch(config)#ipv6 mld snooping vlan-config 2-3 mtime 400
Switch(config)#show ipv6 mld snooping vlan 2
Vlan Id: 2
Router Time:500
Member Time:400
Static Router Port:None
Dynamic Router Port:None
Forbidden Router Port:None
Switch(config)#show ipv6 mld snooping vlan 3
Vlan Id: 3
Router Time:500
Member Time:400
Static Router Port:None
Dynamic Router Port:None
Forbidden Router Port:None
Switch(config)#end
Switch#copy running-config startup-config

Configuring Static Router Port

Step 1 configure
Enter global configuration mode.
Step 2 ipv6 mld snooping vlan-config vlan-id-list [rport interface {gigabitEthernet port-list | port-
channel port-channel-id }]
port-list
and are the static router ports in the specified VLAN.
port-channel-id
Configuring MLD Snooping
Configuration Guide 329