Configuring Replace Source Ip - TP-Link T1600G-18TS Configuration Manual

Configuring Layer 2 Multicast
The following example shows how to configure VLAN 5 as the multicast VLAN, and set port
1/0/6 as the forbidden router port:
Switch#configure
Switch(config)#ipv6 mld snooping
Switch(config)#ipv6 mld snooping multi-vlan-config 5 router-ports-forbidden interface
gigabitEthernet 1/0/6
Switch(config)#show ipv6 mld snooping multi-vlan
Multicast Vlan:Enable
Vlan Id: 5
Router Time:300
Member Time:260
Replace Source IP:::
Static Router Port:None
Dynamic Router Port:None
Forbidden Router Port:Gi1/0/6
Switch(config)#end
Switch#copy running-config startup-config

Configuring Replace Source IP

Step 1 configure
Enter global configuration mode.
Step 2 ipv6 mld snooping multi-vlan-config [ vlan-id ] replace-sourceip ip
vlan-id
ip
sent by the multicast VLAN with the IP address you enter.
Step 3 show ipv6 mld snooping multi-vlan
Show the MLD snooping configuration in the multicast VLAN.
Step 4 end
Return to privileged EXEC mode.
Step 5 copy running-config startup-config
Save the settings in the configuration file.
specifies the multicast VLAN to be configured.
specifies the new source IP. The switch will replace the source IP in the MLD multicast data
Configuring MLD Snooping
Configuration Guide 335