TP-Link T1600G-18TS Configuration Manual page 638

Configuring Network Security
3) Disable 802.1X authentication on port 1/0/2 and port 1/0/3. Enable 802.1X
authentication on port 1/0/1, set the control mode as auto, and set the control type as
MAC based.
Switch_A(config)#interface gigabitEthernet 1/0/2
Switch_A(config-if)#no dot1x
Switch_A(config-if)#exit
Switch_A(config)#interface gigabitEthernet 1/0/3
Switch_A(config-if)#no dot1x
Switch_A(config-if)#exit
Switch_A(config)#interface gigabitEthernet 1/0/1
Switch_A(config-if)#dot1x
Switch_A(config-if)#dot1x port-method mac-based
Switch_A(config-if)#dot1x port-control auto
Switch_A(config-if)#exit
Verify the Configurations
Verify the global configurations of 802.1X authentication:
Switch_A#show dot1x global
802.1X State:
Authentication Method:
Handshake State:
Guest VLAN State:
Guest VLAN ID:
802.1X Accounting State:
Quiet-period State:
Quiet-period Timer:
Max Retry-times For RADIUS Packet: 3
Supplicant Timeout:
Enabled
EAP
Enabled
Disabled
N/A
Disabled
Enabled
10 sec.
3 sec.
Configuration Examples
Configuration Guide 615