TP-Link T1600G-18TS Configuration Manual page 138

Configuring LAG
Step 4
Step 5
Step 6
The following example shows how to add ports1/0/5-8 to LAG 2 and set the mode as static
LAG:
Switch#configure
Switch(config)#interface range gigabitEthernet 1/0/5-8
Switch(config-if-range)#channel-group 2 mode on
Switch(config-if-range)#show etherchannel 2 summary
Flags: D - down
I - stand-alone
R - layer3
u - unsuitable for bundling
Group Port-channel
----- ---------
2 Po2(S)
Switch(config-if-range)#end
Switch#copy running-config startup-config
 Configuring LACP
Follow these steps to configure LACP:
Step 1
show etherchannel num summary
Verify the configuration of the static LAG.
: The group number of the LAG.
num
end
Return to privileged EXEC mode.
copy running-config startup-config
Save the settings in the configuration file.
P - bundled in port-channel
H - hot-standby(LACP only)
S - layer2
Protocol
-------
-
configure
Enter global configuration mode.
U - in use
s - suspended
f - failed to allocate aggregator
w - waiting to be aggregated
Ports
-------------------------------
Gi1/0/5(D) Gi1/0/6(D) Gi1/0/7(D) Gi1/0/8(D)
LAG Configuration
d - default port
Configuration Guide 115