TP-Link T1600G-18TS Configuration Manual page 165

Managing MAC Address Table
Follow these steps to configure MAC notification traps:
1) In the MAC Notification Global Config section, enable this feature, configure the
relevant options, and click Apply.
Global Status
Table Full
Notification
Notification
Interval
2) In the MAC Notification Port Config section, select your desired port and enable its
notification traps. You can enable these three types: Learned Mode Change, Exceed
Max Learned and New MAC Learned. Click Apply.
Learned Mode
Change
Exceed Max
Learned
New MAC
Learned
3) Configure SNMP and set a management host. For detailed SNMP configurations, please
refer to
Configuring SNMP & RMON
Enable MAC notification feature globally.
Enable Table Full Notification, and when address table is full, a notification will be
generated and sent to the management host .
Specify a time value in seconds between 1 to 1000 to bundle the notifications and
reduce traffic. Notification Interval is the interval time between each set of New
MAC Learned notifications that are generated. By default, it is 1 second.
Enable Learned Mode Change, and when the learned mode of the specified port
is changed, a notification will be generated and sent to the management host.
Enable Exceed Max Learned, and when the maximum number of learned MAC
addresses on the specified port is exceeded, a notification will be generated and
sent to the management host.
For Exceed-max-learned notification, you need to enable Port Security and set
the maximum number of learned MAC addresses on the specified port. For more
information about Port Security, please refer to
Enable New MAC Learned, and when the specified port learns a new MAC
address, a notification will be generated and sent to the management host.
.
Security Configurations
Managing Physical Interfaces.
Configuration Guide 142