Configuring Static Router Port - TP-Link T1600G-18TS Configuration Manual

Configuring Layer 2 Multicast
Member Time:400
Static Router Port:None
Dynamic Router Port:None
Forbidden Router Port:None
Switch(config)#end
Switch#copy running-config startup-config

Configuring Static Router Port

Step 1 configure
Enter global configuration mode.
Step 2 ip igmp snooping vlan-config vlan-id-list [rport interface {gigabitEthernet port-list | port-
channel port-channel-id }]
port-list
Step 3 show ip igmp snooping vlan vlan-id
Show the basic IGMP snooping configuration in the specified VLAN.
Step 4 end
Return to privileged EXEC mode.
Step 5 copy running-config startup-config
Save the settings in the configuration file.
The following example shows how to enable IGMP Snooping in VLAN 2 and configure port
1/0/2 as the static router port:
Switch#configure
Switch(config)#ip igmp snooping
Switch(config)#ip igmp snooping vlan-config 2 rport interface gigabitEthernet 1/0/2
Switch(config)#show ip igmp snooping vlan 2
Vlan Id: 2
Router Time:0
Member Time:0
Static Router Port:Gi1/0/2
Dynamic Router Port:None
Forbidden Router Port:None
Switch(config)#end
and are the static router ports in the specified VLAN.
port-channel-id
IGMP Snooping Configurations
Configuration Guide 293