TP-Link T1600G-18TS Configuration Manual page 405

Configuring Logical Interfaces
Link-local
Address
Status
3) Configure one or more IPv6 global addresses of the interface via following three ways:
Via RA Message:
Enable global
address auto
configuration via
RA message
Via DHCPv6 Server:
Enable global
address auto
configuration via
DHCPv6 Server
Manually:
Address Format
Global Address
4) View the global address entry in the Global Address Table.
Global Address
Prefix Length
Type
Preferred
Lifetime
Enter a link-local address if you choose "Manual" as the link-local address
configuration mode.
Displays the status of the link-local address.
Normal: Indicates that the link-local address is normal.
Try: Indicates that the link-local address may be newly configured.
Repeat: Indicates that the link-local address is duplicate. It is illegal to access the
switch using the IPv6 address (including link-local and global address).
With this option enabled, the switch automatically configures a global address
and other information according to the address prefix and other configuration
parameters from the received RA (Router Advertisement) message.
With this option enabled, the switch will try to obtain the global address from the
DHCPv6 Server.
Select the global address format according to your needs.
EUI-64: Indicates that you only need to specify an address prefix, then the
system will create a global address automatically.
Not EUI-64: Indicates that you have to specify an intact global address.
When EUI-64 is selected, please input the address prefix here, otherwise, please
input an intact IPv6 address here.
View and modify the global address.
View and modify the prefix length of the global address.
Displays the configuration mode of the global address.
Manual: Indicates that the corresponding address is configured manually.
Auto: Indicates that the corresponding address is created automatically using
the RA message or obtained from the DHCPv6 Server.
Displays the preferred lifetime of the global address.
Logical Interfaces Configurations
Configuration Guide 382