Creating Multicast Vlan And Configuring Basic Settings - TP-Link T1600G-18TS Configuration Manual

Configuring Layer 2 Multicast
Choose the menu Multicast > MLD Snooping > Multicast VLAN to load the following page.
Figure 3-4 Multicast VLAN Config

Creating Multicast VLAN and Configuring Basic Settings

In the Multicast VLAN section, follow these steps to enable Multicast VLAN and to finish the
basic settings:
1) Set up the VLAN that the router ports and the member ports are in. For details, please
refer to
Configuring 802.1Q
2) Enable Multicast VLAN, configure the specific VLAN to be the multicast VLAN, and
configure the Router Port Time and Member Port Time.
Multicast VLAN
VLAN ID
Router Port
Time
VLAN.
Select Enable to enable multicast VLAN function.
Specify the 802.1Q VLAN to be the multicast VLAN.
Specify the aging time of the router ports in the multicast VLAN. If the router port
does not receive any MLD general query message within the router port time,
the switch will no longer consider this port as a router port and delete it from the
router port table. The valid values are from 60 to 600 seconds. When the router
port time is 0, the VLAN uses the global time.
Configuring MLD Snooping
Configuration Guide 312