Configuring Storm Control - TP-Link T1600G-18TS Configuration Manual

Configuring QoS
Egress Rate (1-
1000000Kbps)
LAG
2) Click Apply.

3.1.2 Configuring Storm Control

Choose the menu QoS > Bandwidth Control > Storm Control to load the following page.
Figure 3-2 Storm Control
Follow these steps to configure the Storm Control function:
1) Select the port(s) and configure the upper rate limit for forwarding broadcast packets,
multicast packets and UL frames.
PPS
Configure the bandwidth for sending packets on the port. The valid values are
from 1 to 1000000 Kbps.
Displays the aggregation group which the port is in.
Enable or disable the PPS (Packets Per Second) mode on the port.
With PPS enabled, the upper rate limit of the broadcast, multicast and UL-frame
can only be specified in packets per second. With PPS disabled, the upper rate
limit of the broadcast, multicast and UL-frame cannot be specified in packets per
second.
Bandwidth Control Configuration
Configuration Guide 449