Configuring Fast Leave - TP-Link T1600G-18TS Configuration Manual

Configuring Layer 2 Multicast
Switch(config)#ipv6 mld snooping
Switch(config)#ipv6 mld snooping rtime 200
Switch(config)#ipv6 mld snooping mtime 200
Switch(config)#show ipv6 mld snooping
MLD Snooping
Unknown Multicast
Last Query Times
Last Query Interval
Global Member Age Time
Global Router Age Time
Global Report Suppression
Enable Port:
Enable VLAN:
Switch(config)#end
Switch#copy running-config startup-config

Configuring Fast Leave

Step 1 configure
Enter global configuration mode.
Step 2 interface {fastEthernet port | range fastEthernet port-list | gigabitEthernet port | range
gigabitEthernet port-list | port-channel port-channel-id | range port-channe port-channel-list }
Enter interface configuration mode
Step 3 ipv6 mld snooping immediate-leave
Enable Fast Leave on the specified port. With Fast Leave enabled on a port, the switch will
delete the port-multicast group entry from the multicast forwarding table once the port
receives a leave message. You should only use this function when there is a single receiver
present on the port.
Step 4 show ipv6 mld snooping interface [fastEthernet [ port | port-list ] | gigabitEthernet [ port |
port-list ]] basic-config
Show the basic MLD snooping configuration on the specified port(s) or of all the ports.
Step 5 end
Return to privileged EXEC mode.
Step 6 copy running-config startup-config
Save the settings in the configuration file.
:Enable
:Pass
:2
:1
:200
:200
:Disable
Configuring MLD Snooping
Configuration Guide 325