Creating Snmp Users - TP-Link T1600G-18TS Configuration Manual

Configuring SNMP & RMON
Read View
Write View
Notify View

2.1.4 Creating SNMP Users

Choose the menu SNMP > SNMP Config > SNMP User to load the following page.
Figure 2-4 SNMP User
Follow these steps to create an SNMP user:
1) Specify the user name, user type and the group which the user belongs to. Set the
security model according to the related parameters of the specified group. If you
choose SNMPv3, you need to configure the security level.
User Name
User Type
Group Name
Choose a view to allow parameters to be viewed but not modified by the NMS.
The view is necessary for any group. By default, the view is viewDefault. To modify
parameters of a view, you need to add it to Write View.
Choose a view to allow parameters to be modified but not viewed by the NMS.
The default is none. The view in Write View should also be added to Read View.
Choose a view to allow it to send notifications to the NMS.
Set the SNMP user name. You may use 1 to 16 characters. For different entries,
user names cannot be the same.
Choose a user type to indicate the location of the user. The default is Local User.
Local User: The user resides on the local engine, which is the SNMP Agent of the
switch.
Remote User: The user resides on a remote engine, which is the SNMP Agent of
some other device. For this user type, you need to set the remote engine ID first.
Choose the group that the user belongs to. Users with the same Group Name,
Security Model and Security Level will be in the same group.
SNMP Configurations
Configuration Guide 699