Configuring Max Group And Overflow Action On The Port - TP-Link T1600G-18TS Configuration Manual

Configuring Layer 2 Multicast
Step 3 ip igmp snooping immediate-leave
Enable Fast Leave on the specified port. With Fast Leave enabled on a port, the switch will
delete the port-multicast group entry from the multicast forwarding table once the port
receives a leave message. You should only use this function when there is a single receiver
present on the port.
Step 4 show ip igmp snooping interface [fastEthernet [ port | port-list ] | gigabitEthernet [ port | port-
list ]] basic-config
Show the basic IGMP snooping configuration on the specified port(s) or of all the ports.
Step 5 end
Return to privileged EXEC mode.
Step 6 copy running-config startup-config
Save the settings in the configuration file.
The following example shows how to enable Fast Leave on port 1/0/3:
Switch#configure
Switch(config)#ip igmp snooping
Switch(config)#interface gigabitEternet 1/0/3
Switch(config-if)#ip igmp snooping
Switch(config-if)#ip igmp snooping immediate-leave
Switch(config-if)#show ip igmp snooping interface gigabitEthernet 1/0/3 basic-config
Port IGMP-Snooping
---- -------------
Gi1/0/3
Switch(config-if)#end
Switch#copy running-config startup-config

Configuring Max Group and Overflow Action on the Port

Step 1 configure
Enter global configuration mode.
Step 2 interface {fastEthernet port | range fastEthernet port-list | gigabitEthernet port | range
gigabitEthernet port-list | port-channel port-channel-id | range port-channe port-channel-list }
Enter interface configuration mode
Step 3 ip igmp snooping max-groups maxgroup
Enter the number of multicast groups the port can join. The range is 0 to 1000.
Fast-Leave
----------
enable enable
IGMP Snooping Configurations
Configuration Guide 289