Viewing Ipv6 Routing Table - TP-Link T1600G-18TS Configuration Manual

Configuring Static Routing

4.1.2 Viewing IPv6 Routing Table

Choose the menu Routing> Routing Table > IPv6 Routing Table to load the following
page.
Figure 4-2 Viewing IPv6 Routing Table
View the IPv6 routes in the IPv6 Routing Information Summary section.
Protocol
Destination
Network
Next Hop
Distance
Metric
Interface Name
4.2 Using the CLI
4.2.1 Viewing IPv4 Routing Table
On privileged EXEC mode or any other configuration mode, you can use the following
command to view IPv4 routing table:
show ip route [ static | connected ]
View the IPv4 route entries of the specified type. If not specified, all types of route entries will be displayed.
static: View the static routes.
connected: View the connected routes.
Displays the type of the route entry.
Displays the destination IP address and subnet mask.
Displays the IPv6 gateway address to which the packet should be sent next.
Displays the administrative distance which is a rating of the trustworthiness of a
routing information. A higher value means a lower trust rating. When more than one
routing protocols have routes to the same destination, only the route which has the
smallest distance will be recorded in the IP routing table.
Displays the metric to reach the destination IP address.
Displays the gateway interface name.
Viewing Routing Table
Configuration Guide 398