Editing Ip Range Of The Profile - TP-Link T1600G-18TS Configuration Manual

Configuring Layer 2 Multicast

Editing IP Range of the Profile

Follow these steps to edit profile mode and its IP range:
1) Click Edit in the IGMP Profile Info table. Edit its IP range and click Add to save the
settings.
Figure 2-7 Add IP-range
Profile ID
Mode
Start IP
End IP
2) In the IP-range Table, you can select an IP range and click Delete to delete an IP range.
3) Click Submit to save the settings; click Back to go back to the previous page.
2.1.7 Binding Profile and Member Ports
With this function, you can configure each port's filtering profile and the number of
multicast groups a port can join. Choose the menu Multicast > IGMP Snooping > Profile
Binding to load the following page.
Displays the ID of the profile to be edited.
Select Permit or Deny as the filtering mode.
Permit: similar to a whitelist, means that the switch only allows specified member
ports to join specific multicast groups.
Deny: similar to a blacklist, means that the switch disallows specific member ports
to join specific multicast groups.
Specify the Start IP of the multicast IP range.
Specify the End IP of the multicast IP range.
IGMP Snooping Configurations
Configuration Guide 278