TP-Link T1600G-18TS Configuration Manual page 573

Configuring Network Security
Step 2
Step 3
Step 4
Step 5
The following example shows how to bind an entry with the hostname host1, IP address
192.168.0.55, MAC address AA-BB-CC-DD-EE-FF, VLAN ID 10, port number 1/0/5, and
enable this entry for the ARP detection feature.
Switch#configure
Switch(config)#ip source binding host1 192.168.0.55 aa:bb:cc:dd:ee:ff vlan 10 interface
gigabitEthernet 1/0/5 arp-detection
Switch(config)#show ip source binding
U No. Host
-- --- -------
1 1 host1
Switch(config)#end
Switch#copy running-config startup-config
ip source binding hostname ip-addr mac-addr vlan vlan-id interface gigabitEthernet
port { none | arp-detection } [ forced-source {arp-scanning | dhcp-snooping} ]
Manually bind the host name, IP address, MAC address, VLAN ID and port number of
the host, and configure the protect type for the host. In addition, you can change the
source of the entry as ARP Scanning or DHCP Snooping.
: Specify a name for the host. It contains 20 characters at most.
hostname
: Enter the IP address of the host.
ip-addr
: Enter the MAC address of the host, in the format of xx:xx:xx:xx:xx:xx.
mac-addr
: Enter the VLAN ID of the host.
vlan-id
: Enter the number of the port on which the host is connected.
port
none | arp-detection : Specify the protect type for the entry. None indicates this entry
will not be applied to ARP Detection; arp-detection indicates this entry will be applied
to ARP Detection.
arp-scanning | dhcp-snooping:
DHCP Snooping.
show ip source binding
Verify the binding entry.
end
Return to privileged EXEC mode.
copy running-config startup-config
Save the settings in the configuration file.
IP-Addr
--------
192.168.0.55
Change the source of the entry to ARP Scanning or
MAC-Addr VID
-------- ------
aa:bb:cc:dd:ee:ff 10
IP-MAC Binding Configurations
Port ACL
----- ------
Gi1/0/5 ARP-D
Configuration Guide
Col.
-----
550