Configuring Ipv6 Parameters Of The Interface - TP-Link T1600G-18TS Configuration Manual

Configuring Logical Interfaces
IP Address Mode
IP Address
Subnet Mask
Admin Status
Interface Name
2) In the Secondary IP Create section, configure the secondary IP for the specified
interface which allows you to have two logical subnets using one physical subnet. Then
click Create.
3) In the Secondary IP List section, you can view the corresponding secondary IP entry
you create.

2.1.3 Configuring IPv6 Parameters of the Interface

In Figure 2-1 , you can view the corresponding interface entry you create in the Interface
List section. On the corresponding interface entry, click Edit IPv6 to load the following
page and configure the IPv6 parameters of the interface.
Specify the IP address assignment mode of the interface.
None: No IP address will be assigned.
Static: Assign an IP address manually.
DHCP: Assign an IP address through DHCP .
BOOTP: Assign an IP address through BOOTP.
Specify the IP address of the interface if you choose "Static" as the IP address
assignment mode.
Specify the subnet mask of the interface's IP address.
Enable or disable the interface's Layer 3 capabilities.
(Optional) Enter the name of the interface.
Logical Interfaces Configurations
Configuration Guide 380