Configuring The Querier - TP-Link T1600G-18TS Configuration Manual

Configuring Layer 2 Multicast
The following example shows how to configure VLAN 5 as the multicast VLAN and replace
the source IP in the MLD packets sent by the switch with FE80::02FF:FFFF:FE00:0001:
Switch#configure
Switch(config)#ipv6 mld snooping
S w i t c h ( c o n f i g ) # i p v 6 m l d s n o o p i n g m u l t i - v l a n - c o n f i g 5 r e p l a c e - s o u r c e i p
fe80::02ff:ffff:fe00:0001
Switch(config)#show ipv6 mld snooping multi-vlan
Multicast Vlan:Enable
Vlan Id: 5
Router Time:300
Member Time:260
Replace Source IP:fe80::2ff:ffff:fe00:1
Static Router Port:None
Dynamic Router Port:None
Forbidden Router Port:None
Switch(config)#end
Switch#copy running-config startup-config

3.2.8 Configuring the Querier

Enabling MLD Querier
Step 1 configure
Enter global configuration mode.
Step 2 ipv6 mld snooping querier vlan vlan-id
vlan-id
Step 3 show ipv6 mld snooping querier [vlan vlan-id ]
Show the MLD querier configuration.
Step 4 end
Return to privileged EXEC mode.
Step 5 copy running-config startup-config
Save the settings in the configuration file.
specifies the VLAN to enable MLD Querier.
Configuring MLD Snooping
Configuration Guide 336