Dhcp Snooping Configuration - TP-Link T1600G-18TS Configuration Manual

Configuring Network Security
3

DHCP Snooping Configuration

To complete DHCP Snooping configuration, follow these steps:
1) Enable DHCP Snooping on VLAN.
2) Configure DHCP Snooping on the specified port.
3) (Optional) Configure Option 82 on the specified port.
The switch can dynamically bind the entries via DHCP Snooping after step 1 and step
Tips:
2 are completed. By default, the binding entries are applied to ARP Detection.
Configuration Guidelines
DHCP Snooping and DHCP Relay cannot be used at the same time on the switch. When
both of these features are enabled, only DHCP Relay will work.
3.1 Using the GUI
3.1.1 Enabling DHCP Snooping on VLAN
Choose the menu Network Security > DHCP Snooping > Global Config to load the
following page.
Figure 3-1 Global Config
Follow these steps to enable DHCP Snooping:
1) Globally enable DHCP Snooping.
2) Enable DHCP Snooping on a VLAN or range of VLANs.
DHCP Snooping Configuration
Configuration Guide 552