Dhcp Client Configuration - TP-Link T1600G-18TS Configuration Manual

Configuring DHCP
2

DHCP Client Configuration

2.1 Using the GUI
Choose the menu Routing > Interface > Interface Config to load the following page.
Figure 2-1 DHCP Client Configuration
Follow these steps to configure DHCP client:
1) In the Creating Interface section, select Interface VLAN or Routed Port as the interface
type and enter the interface ID. Select DHCP or BOOTP as the IP Address Mode. Set the
Admin Status as Enable, and enter the Interface Name (optional).
Interface ID
IP Address
Mode
Admin Status
Interface Name
2) Click Create.
Select an interface type and enter the ID of the interface. If you select VLAN, enter
a VLAN ID. If you select Routed port, enter a port number.
Select DHCP or BOOTP as the IP address assignment mode.
DHCP: Assign an ip address for the interface through DHCP.
BOOTP: Assign an ip address for the interface through BOOTP.
Enable or disable the interface's Layer 3 capabilities.
(Optional) Specify a name for the interface.
DHCP Client Configuration
Configuration Guide 409