TP-Link T1600G-18TS Configuration Manual page 677

Configuring LLDP
Switch_A(config)#lldp timer tx-interval 30 tx-delay 2 reinit-delay 3 notify-interval 5 fast-
count 3
2) Set the Admin Status of port Gi1/0/1 to Tx&Rx, enable Notification Mode and configure
all the TLVs included in the outgoing LLDP packets.
Switch_A#configure
Switch_A(config)#interface gigabitEthernet 1/0/1
Switch_A(config-if)#lldp receive
Switch_A(config-if)#lldp transmit
Switch_A(config-if)#lldp snmp-trap
Switch_A(config-if)#lldp tlv-select all
Switch_A(config-if)#end
Switch_A#copy running-config startup-config
Verify the Configurations
View LLDP settings globally
Switch_A#show lldp
LLDP Status:
LLDP Forward Message:
Tx Interval:
TTL Multiplier:
Tx Delay:
Initialization Delay:
Trap Notification Interval:
Fast-packet Count:
LLDP-MED Fast Start Repeat Count: 4
View LLDP settings on each port
Switch_A#show lldp interface gigabitEthernet 1/0/1
LLDP interface config:
gigabitEthernet 1/0/1:
Admin Status:
SNMP Trap:
Enabled
Disabled
30 seconds
4
2 seconds
2 seconds
5 seconds
3
TxRx
Enabled
Configuration Example
Configuration Guide 654