Set Port Redundancy; Set Port Redundancy On/Off - Avaya P460 Reference Manual

Chapter 2 Avaya P460 CLI Commands
The syntax for this command is:
set port negotiation <module>/<port> {enable|disable}
module
port
enable
disable
Example:
To disable autonegotiation on port 1, module 4:
P460-1# set port negotiation 4/1 disable
Link negotiation protocol disabled on port 4/1.

set port redundancy

User level: read-write, admin.
Use the set port redundancy command to globally enables or disable the
redundancy pairs you have defined. Using this command will not delete existing
redundancy entries.
You must disable Spanning Tree before you can enable redundancy.
The syntax for this command is:
set port redundancy {enable|disable}
Example:
P460-1# set port redundancy enable
All redundancy schemes are now enabled

set port redundancy on/off

User level: read-write, admin.
Use the set port redundancy command to defines or remove redundancy pairs. The
link can be any port that does not belong to a LAG, or a LAG interface. Ensure that
94
Number of the module (3-6). If you do not specify a number,
the ports on all the modules are shown.
Number of the port on the module. If you do not specify a
number, all the ports on the module are shown.
You can also specify a range of ports separated by a dash, for
example, 4/5-13 for ports 5 to 13 on module 4.
Enable port negotiation protocol
Disable port negotiation protocol
Avaya P460 Reference Guide