Boot Run Procedure - Mitsubishi Q00JCPU User Manual

11
PROCEDURE FOR WRITING PROGRAM TO CPU
MODULE

11.2.5 Boot run procedure

This section explains a boot run procedure.
In the following procedure,
indicates that on the Basic model QCPU side.
Start (Continued from
Section 11.2.3,11.2.4)
When the RUN/STOPT switch is in the
RUN position, set the switch to the
STOP position.
In the boot file setting of the PLC
parameter dialog box, set the parameter,
program, device initial value and device
comment file names to be read from the
standard ROM or memory card.
In the program setting of the PLC
parameter dialog box, set the program
names to be executed and their execution
conditions (they must also be set if one
program is to be executed).
Set the parameter-valid drive of the DIP
switches (SW2, SW3).
Choose [Online]
on GX Developer, and format the
memory.
Choose [Online]
ROM)]
GX Developer, and write data to the
memory set as the "transfer source" in
the boot file setting.
Power the PLC OFF and then ON, or
reset the CPU module.
NO
1 : Refer to the following manual for the procedure when the Redundant CPU is used.
Use the standard
NO
RAM or memory card
(except Flash card)?
YES
[Format PLC memory]
[Write to PLC (Flash
[Write to PLC (Flash ROM)] on
Is the BOOT
LED on?
YES
End
QnPRHCPU User's Manual (Redundant System)
Diagram 11.7 Boot run flowchart
11.2 High Performance Model QCPU, Process CPU, Redundant CPU
indicates the operation on the GX Developer side, and
Section 5.2.8
Section 3.3.6
Part names and settings of QCPU User's Manual
(Hardware Design, Maintenance and Inspection)
GX Developer Operating Manual
Section 5.2.5
1
11.2.5 Boot run procedure
9
10
11
11
- 16