Mitsubishi Q00JCPU User Manual page 593

11
PROCEDURE FOR WRITING PROGRAM TO CPU
MODULE
1)
NO
Use the device
initial value?
YES
Set the device memory.
Set the device initial value range.
In the PLC file setting of the PLC
parameter dialog box, set the device initial
value file name.
NO
Designate local
devices?
YES
In the device setting item in the PLC
parameter, designate the name of the local
device range.
In the PLC file setting in the PLC parameter,
designate the name of the local device file.
NO
Use the common
pointers?
YES
In the PLC system setting item in the PLC
parameter, designate the first pointer No.
In the program settings in the PLC
parameter, designate the name of the
program to be executed, and its execution
condition.
Set the parameter-valid drive of the DIP
switches (SW2, SW3)."
2)
* 1 : By default, the parameter-valid drive is set to the program memory (Drive 0)with the DIP switches.
(SW2: OFF, SW3: ON)
When writing the parameters to the standard ROM or memory card, change the parameter-valid
drive with the DIP switches.
11.2 High Performance Model QCPU, Process CPU, Redundant CPU
Section 6.26
Section 6.26
Section 6.26
Section 9.13.1
Section 9.13.1
Section 9.9.2
Section 3.3.6
1
Part names and settings of QCPU User's
Manual (Hardware Design, Maintenance and
Inspection)
11.2.4 Procedure for writing multiple programs
9
10
11
11
- 14