Mitsubishi Q00JCPU User Manual page 108

3
SEQUENCE PROGRAM CONFIGURATION AND
EXECUTION CONDITIONS
Main routine program
Subroutine program in
stand-by type program
Interrupt program in stand-
by type program
Diagram 3.39 Operation of subroutine and interrupt programs in stand-by type program
Redundant
Note3.22
Note22
Redundant
Note3.22
3
3.3 Settings for Creation and Execution of Multiple Sequence Programs
- 43
3.3.4 Stand-by type program
1) Operation of subroutine and interrupt programs in stand-by type
program
When the execution of the stand-by type program is finished, a program in the
stand-by type program is called and its execution is resumed.
Diagram 3.39 shows the operation performed when the subroutine and
interrupt programs in the stand-by type program is executed.
CALL P100 instruction execution
END processing
P100
POINT
1. Refer to the following section for restrictions on subroutine or interrupt
program creation.
• Subroutine program
• Interrupt program
2. Use common pointers.(
When local pointers are used, the subroutine programs in the stand-by type
program cannot be executed from another program.
(b) When changing execution type by instruction
Use the PSCAN, PLOW
execution type.Note22
Since the Redundant CPU cannot use low speed execution type programs, it cannot change the
execution type using the PLOW instruction.
END processing
RET
: Section 3.1.2
: Section 3.1.3
Section 9.9.2)
Note3.22
, PSTOP and/or POFF instruction to change the
Interrupt factor occurrence
END processing
I0 IRET