Mitsubishi Q00JCPU User Manual page 314

6
FUNCTIONS
(3) Startup program
Basic
Note6.28
Redundant
Note6.29
Note28
Basic
Note6.28
Note29
Redundant
Note6.29
6
6.13 Execution Time Measurement
- 73
6.13.1 Program list monitor
Note6.28
Program can be started on the program list monitor screen.
Clicking the
Startup program
(a)
(b)
(a) Program name
Select the program set in the program setting of the PLC parameter dialog box.
A program name cannot be entered as desired.
(b) Startup mode
The stand-by type program can be changed to "Scan execution", "Low speed
Note6.29
execution"
The value set in the program setting of the PLC parameter dialog box is displayed
as the default value of fixed scan execution. ms or scan be selected as the
unit.Note29
In the case of Basic model QCPU, a program cannot be started from the program list monitor
screen.
Since the Redundant CPU cannot use low speed execution type programs, "Low speed
execution" cannot be selected in the start mode.
Note28
button displays the following dialog box.
Diagram 6.44 Startup program screen
or "Fixed scan execution".